- Created By admin@decibel
- Last Updated November 9th, 2021
Radiography Testing (RT)
This method is based on the same principle as medical radiography in a hospital. A piece of radiographic film is placed on the remote side of the material under inspection and radiation is then transmitted through from one side of the material to the remote side where the radiographic film is placed.
The radiographic film detects the radiation and measures the various quantities of radiation received over the entire surface of the film. This film is then processed under dark room conditions and the various degrees of radiation received by the film are imaged by the display of different degrees of black and white, this is termed the film density and is viewed on a special light emitting device.
Discontinuities in the material affect the amount of radiation being received by the film through that particular plane of the material. Qualified inspectors can interpret the resultant images and record the location and type of effect present in the material. Radiography can be used on most materials and product forms, e.g. welds, castings, composites etc.
Radiographic testing provides a permanent record in the form of a radiograph and provides a highly sensitive image of the internal structure of the material. Radiography is split into two main categories.
- Radiographic Testing
- Radiographic Interpretation
The radiographic testing course is for NDT personnel who execute the practical inspection using radioactive material or radiation emitting devices. The radiographic interpretation course is designed purely for the interpretation of the resultant radiographic image. However, to understand the principles of image formation, sensitivity and correct techniques the general theory syllabus is the same for both courses.
The two sectors of the Radiographic Testing examination that are NOT required for the Radiographic Interpretation examination are.
- Basic Radiation Safety (BRS)
- Practical Examination of the Specimens
SNT-TC-1A minimum work experience and training hours’ requirements for RT examinations
- 40 hours Training SNT-TC-1A
- 210 hours experience in method & 400 hours in NDT
If a candidate wishes to go direct to Level 2 without first taking the Level 1 route, the minimum requirements are the total accumulative requirements of both Level 1 and 2.
We can provide Radiographic Testing and Interpretation training courses and examinations suitable for any of the following certification scheme
- SNT-TC-1A in accordance with your/our company written practice
We can also provide
- Preparation training for ASNT Level 3
An example of the syllabus that is used for Radiographic training courses is shown below for Level 1. DECIBEL can tailor make the syllabus to satisfy the requirements of an individual’s company specific written practice if requested.
Radiographic Testing is split into specific product sectors for certification at Level, this is
Each of these categories is further split into sub groups
- Light Metal X-ray
- Dense Metal X-ray (and/or Gamma ray)
- Light and Dense Metal, both X-ray and Gamma ray
For PCN: Refer PCN General Requirements Document
For NAS410/EN4179/SNT-TC-1A: According to Written Practice.
For ACCP: Refer ACCP General Requirements Document.
Will vary depends on the type of certification chosen